Back to Blog
How-to Guides 2026-11-20 Garage Alpha: Titanium Hood Props, Carbon Fiber Door Sills ... 0 views

Mazda RX-7 FD3S Fan Relay Covers Installation Guide

Mazda RX-7 FD3S Fan Relay Covers Installation Guide

Step-by-step instructions for installing new Garage Alpha fan relay covers on your FD3S RX-7. Replace faded, cracked originals to protect critical cooling fans.

Why Replace Your FD3S Fan Relay Covers?

The factory fan relay covers on your Mazda RX-7 FD3S were never sold separately—Mazda only supplied them as part of a full relay assembly. After years of engine bay heat, those covers are likely cracked, dry-rotted, or just plain ugly. Beyond appearance, damaged covers leave the fan relays exposed to moisture and debris. Since a failed fan can lead to overheating and engine failure, keeping these covers in good shape is a genuine reliability concern.

Garage Alpha had new covers made specifically for the FD3S so you can replace the originals without buying an entire relay set. This guide walks you through the simple swap.

What the Set Includes

  • Mazda RX-7 [FD3S] Fan Relay Covers: Every set includes three 'large' and one 'small' cover which is enough to make all your fan relay covers look good as new! You get everything needed to replace all the fan relay covers in one order—no need to source individual pieces.
    Mazda RX-7 [FD3S] Fan Relay Covers
    Mazda RX-7 [FD3S] Fan Relay Covers
  • Mazda RX-7 [FD3S] Fan Relay Covers: These covers were NEVER available from Mazda without a fully set of relays - but we went out of our way to have these made because we want your engine bay looking the best it can look. This is a rare aftermarket solution for a part that was not available separately from the factory.

Installation Steps

The installation is straightforward and requires no special tools. Work on a cool engine to avoid burns.

  1. 1. Inspect the old covers: Open the hood and look at each fan relay cover. If they are faded, cracked, or brittle, they need replacement. Note the position of each cover (three large, one small) so you match the new ones correctly.
  2. 2. Remove the old covers: Gently pry off each old cover. They are usually held by friction clips or simple snaps. Take care not to damage the relay sockets underneath.
  3. 3. Clean the relay area: Wipe away any dust, grease, or debris from the relay bases. A clean surface ensures the new covers seat properly.
  4. 4. Fit the new Garage Alpha covers: Press each new cover onto its corresponding relay base. Start with the three large covers, then the small one. They should click into place without excessive force.
  5. 5. Verify secure fit: Gently tug each cover to confirm it is locked in place. A loose cover could vibrate off while driving.
  6. 6. Optional: Add the driver side A/C cover: If you ordered the optional driver side A/C cover, install it following the same press-fit method. This covers the A/C relay on the driver side for a uniform look.

Pre-Order Lead Time

These covers are made to order, so plan ahead. The current lead time is approximately 2 months. Order early so you have the covers ready when you schedule your engine bay refresh.

Related Articles

Customer Service
Home
Products
Cart
Profile